my first question

http://ift.tt/2BeJ1oz

Hi all
I have got a tfv8 baby with a RBA
when the RBA is installed the positive pin on the bottom of the tank is pushed out a little further than normal
this makes the tank not sit flush on my mod
leaving a small gap of about 2mm
is there anything available that will fill this gap safely
I have been using a disk/washer made from post it note but want something made for the job that I can wash when I wash the tank between juices

will check back to see your suggestions

Planet Of The Vapes Forum

via New User Questions and Discussion http://ift.tt/2BefYxk

December 7, 2017 at 11:34PM

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s