electronic_cigarette
https://ift.tt/eA8V8J
Wismec RX300 reads 0.02 ohms higher than actual resistance https://ift.tt/2HcuL4y

My RX300 functions fine, everything works as it should. I use it for both ejuice and THC, and in both applications I use TC almost exclusively. Again, it works fine and performs almost on par with my Centaurus 250c which is pretty damn impressive. However, it always reads coils as .02 higher than their true reading. Manually adjusting to .02 lower causes it perform as if you set it roughly .02 too low.

I could, and likely should, leave it alone. But I am curious if there's a way to fix this, or why it even happens? It's consistent, across all coil types and never fluctuates, as if it just adds .02 only in it's own special little world lol.

My RX300 functions fine, everything works as it should. I use it for both ejuice and THC, and in both applications I use TC almost exclusively. Again, it works fine and performs almost on par with my Centaurus 250c which is pretty damn impressive. However, it always reads coils as .02 higher than their true reading. Manually adjusting to .02 lower causes it perform as if you set it roughly .02 too low.I could, and likely should, leave it alone. But I am curious if there’s a way to fix this, or why it even happens? It’s consistent, across all coil types and never fluctuates, as if it just adds .02 only in it’s own special little world lol.

Submitted November 17, 2020 at 05:55AM by theonecarguy
via reddit https://ift.tt/35ANUX1}

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s